|
 |
| I Just Received My Remote Trainer from Repair and the LED Stays Solid Red |
If your system is an XLS, XL or earlier system it is normal for the LED on the transmitter and collar to stay solid
red when plugged into the charger if the system is new or has been repaired. When the system was repaired the
receiver LED was upgraded to the XL configuration. The LED for the XL series is only red; it is no longer red
and green. In addition the indications for on/off, etc., are slightly different.
- Double Blink Red = Collar is turned on
- Glows Red Steadily = Collar is receiving signal from transmitter
- Single Long Red Flash = Collar has been turned off
- Rapid Red Blink = Low batteries, recharge the collar soon. This may occur more quickly in the temperatures
near or below freezing.
- Glows Red Steadily While On Charger = Indicates collar is charging. The light will not flash when
the charging cycle is complete. The collar should always be charged for 14 - 20 hours.
For additional information and a complete list of changes, read the blue paper that came with your unit, or you
can review the Owner's Guides online. If you have any
questions regarding the proper operation of your remote trainer you may contact Customer Service by e-mail or by calling 1-800-456-4343. |
|
